C2-125-DGK Diamond Cutter / Gravers
Non-rotary, 1/8in shank, W/knob
0.118 (D) x 5.0 (L)
diamond Gravers “Drag tools” are tools that are normally use when the spindle
is turn off. This allows the bit to not rotate when engraving. It will only scratch the surface of the
material and doesn’t provide a deep cut.
These tools are normally used on metal
such as brass, aluminum, stainless steel, dog tags and trophies.
The 1/8 shank can be used on the
following Engravers – PNC serials, EGX-20, EGX-30, EGX-300, and EGX-350.